Total Integration Discussion

[feedingear]

Fair enough - dont mean any offense. But you can send audio from OUT 1, 2 and 3 for your parts in the TI as the Virus plugin as three channels in your DAW - just set up the part output individually. For my purposes, I use the USB outs until I am ready to print, then I will send it via OUT 1 L+R as I feel it sounds richer.

Gorgeous studio btw.

[///OSS]

Originally Posted by feedingear

Fair enough - dont mean any offense. But you can send audio from OUT 1, 2 and 3 for your parts in the TI as the Virus plugin as three channels in your DAW - just set up the part output individually. For my purposes, I use the USB outs until I am ready to print, then I will send it via OUT 1 L+R as I feel it sounds richer.

Gorgeous studio btw.

Its cool appreciate that. and thanks!

Yeah I use the multi-outs on the board itself too but not the USB ones, Im just used to using it independently because when i used the USB outs thru the DAW I got that latency and the thinner sound but I never tried to actually use the Analog outs while I had VC on...WWWWOOOPPsss..lol

Sure would've saved me a few frustrating moments. Question is why would you use it any other way? You can setup the exact same scenario if the DAWs audio interface has 6 inputs and retain the realtime playability and still benefit from the DAWs automation and channel features by using direct monitor with only one pass thru the engine instead of 2 by routing via USB.


www.othersidesounds.com
www.pushmp.com