3.0.3 just lost MIDI i/o in Logic Pro 8 - The Unofficial Access Virus & Virus TI Forum

fierlion · #1 10.06.2009, 05:36 AM

'When you play the Kurzweil are you seeing the MIDI information in the transport bar? Do you see it go in and out? Have you checked in your environment that nothing has changed that would cause your MIDI input/output to get lost?'

I see no MIDI in or out. I opened up my environment and see no midi at all in my clicks and ports--nothing. I have the same problem when I downgraded to the previous OS version (which was working perfectly). I also have this problem in ableton live though. I think the problem must be the virus snow's MIDI interface.
When I use the VIRUS standalone--MIDI in is working perfectly. but its MIDI in cuts out the minute logic or live are booted up.
When I use the TI in my former logic projects (including this current one where the problems began) the SNOW reads the MIDI data and plays perfectly.

I'm lost. It's too difficult to put my new GoTo synth in storage. I beg y'all to use your magic of EXPERIENCE and make this right again.

thanks.

toadovsky · #2 10.07.2009, 05:08 AM

I'm also getting this issue in Live 8

Basically updated to Ableton Live 8.0.4 and updated by Snow software and drivers to the latest.

Now I don't get any response via the Midi In on the snow when using Live

Havent tested this extensively, but any ideas on what this issue might be? Anyone else getting this?

overacid · #3 10.07.2009, 07:14 AM

Hey guys,

toadovsky and I have discussed this offline and it seems we are having the same problem. No MIDI signal at all, like it doesn't exist, when trying to use the Virus Control as a VST.

Ableton Live 8 picks up the Virus no worries, but the MIDI in is nowhere to be found.

If anyone is having the same issue and works it out, i'd love to hear what you did to get it going.

I too have recently upgraded the OS to 3.0.3 and also recently to Live 8.04. I'm not sure which of these two things have killed my MIDI-thru-virus, but from the OP's comments it sounds like OS3.0.3 is looking the guilty party.

Cheers

limlo · #4 11.07.2009, 08:28 AM

i have a similiar problem : after some time working in logic ,approx 2 hours, my usb midi interface stops working , i have to unplug - replug and it works again .
this happens since 3.0.3