OS 3.01 and Snow

[Prime NL]

The update went smoothly on my Mac with OS 10.4 till the moment when it starts to install the firmware on my Snow....it then showed the "No device found" error.
Tried the 'All cables off and return with the 'Exit' hold button...but to no avail.

Had to restart my Mac and my Snow to get back to the VC centre...it then would recognise my Snow and did the firmware update perfectly.

Only bug which i could find on my Snow as a standalone is that the volume sometimes tends to go very low.

[Cantankerous]

I have this volume problem using VC in Cubase 4.5.2 as well. I can set a patch to play at a certain volume, but if I reload the project at a later time from scratch the volume of the patch is very, very low and I have to raise it up, then back down to where I want it from within VC to hear it properly.