Virus Ti - Filter cutoff won't track Portamento..?

[RASP]

I may just be tired and answering this entirely wrong, but what about putting your synth in Legato mode as opposed to Poly?

[aitch]

Hi RASP,

I've already tried with all Mono legato modes as well as Poly mode, and still can't get the Filter freq to glide SLOWLY between played notes. Whatever the Portamento value, the Filter freq jumps rapidly between notes, while the Osc pitch glides slowly.
I guess it's a built in limitation, but I won't complain too much as the Virus is, in most respects, an amazing piece of kit, which responds to almost any programming trick I throw at it!
Thanks anyway for taking the trouble to reply to my post.

Best wishes,

Aitch

[RASP]

Yeah, amazing DSP power but its still not control voltages.

I don't own a modular synthesizer but I wonder if this is possible. Portamento on a control voltage synth is a lag processor somewhere in the key control.

[Juho L]

Check out if there's portamento in the source list of modulation matrix. If I recall right it should be there, at least on the B-series.

[RASP]

Originally Posted by Juho L

Check out if there's portamento in the source list of modulation matrix. If I recall right it should be there, at least on the B-series.

Your right, its abbreviated name is "PortaSw."

[aitch]

Thanks everyone, for replies!
Tried your suggestion - unfortunately, the 'Portamento Sw' (matrix source) only represents an ON/OFF controller (similar to sources such as Hold Pedal etc.)

As RASP stated - in older analogue synths, Portamento applies 'lag processing' to the voltage control of Osc pitch, giving slow transition between note changes. The Virus Ti, doesn't seem to have it 'wired' to affect slow transitions between Filter frequency.
I'll try emailing Access - perhaps they'll consider it in a future firmware update.

Thanks again,

Aitch