Cubase SX1 Parameter Problems - The Unofficial Access Virus & Virus TI Forum

techno_7 · #1 07.05.2005, 09:21 PM

Hi!

Heres the thing:

I just bought a Edirol PCR-M50 MIDI controller and i want to assign it's knobs and sliders to Cubase SX's VSTi's but i need to know what MIDI number the parameters on these VSTi's have. Is there any way i can do that without a manual to every single VSTi?

Also, do anyone know how to "bounce" VSTi's?

Fasttracker · #2 08.05.2005, 08:39 AM

Don't know about the vst controll but about the bouncing , can't you just solo the vst's and export audio to the pool and reimport it?
Greetz...

techno_7 · #3 13.05.2005, 02:05 PM

Ok, i have now found out how to use controllers.

But i still have a problem because i dont really get into the VSTi.
I can only control the VSTi mixer which is for volume and sends ect.

Is there any way i can control the parameters INSIDE the VST?

It seems that i can only control the VSTi MIXER, MIDI MIXER, Master MIXER, the transport, and master commands of cubase. Where do i control ONE specific VSTi's parameters and not the mixers?