SEQ MODE problem?

[chris rowand]

Hi there everybody,
I would be grateful to anyone who may offer help..
I am having trouble getting my Virus TI keyboard to output sound on any midi channel when in standalone SEQ MODE.

Used to work ok but since it's update to the recent 3.012. I have been unable to get any sound from it. Local control is on, volumes set high nothing.

It plays fine when using Virus control in Logic and also in single mode without computer attached.
The manual is fairly brief and I'm usually quite good at sorting these things out myself, but this time to no avail. I would like to use this mode when I get my elektron machinedrum, shortly.
Call me stupid but am I doing something wrong. I have spent the best part of a day trying to figure this out..

Any ideas anyone?
Chris

[horsegrip]

Hey Chris,
Maybe when you updated, it reset your settings. In stand-alone mode and in Seq Mode, press multi edit. Cycle through until you find Output(s). With all your parts, select your desired output. Then flash it to ROM.
This should be the trick.
Hope it works
Good Luck

[chris rowand]

Hey horsegrip, you are a star!!!
You have solved all my seq problems and I am very grateful for your reply.
I shall sing your praises to everyone I know. You have put the smile back on my face.
Many thanks for taking the time to reply.
Chris

[horsegrip]

No probs dude.
Sometimes there are things that happen and you don't know what's going on. Believe me, I ask some of the silliest ?'s too. The users of this forum are probably the most dedicated. I hope that you can come to my rescue aswell.
Big Up's to yourself

[annikk.exe]

yay! :grouphug:


-Annikk

[horsegrip]

Hands-across-da-world

[annikk.exe]

::passes blunt::


-Annikk

[horsegrip]

I'm always the one who's left with the roche

[bbsounds]

Originally Posted by horsegrip

Hey Chris,
Maybe when you updated, it reset your settings. In stand-alone mode and in Seq Mode, press multi edit. Cycle through until you find Output(s). With all your parts, select your desired output. Then flash it to ROM.
This should be the trick.
Hope it works
Good Luck

Hi, i am new here and I have the same exact problem as the original poster but forgive me for being a little dens , I am not sure how to flash my ti2 desktop. I do not get any sound output from single mode and seq mode when In standalone as well and I tried to follow what you advised but i am kinda lost at how to select al the parts and then flash

I am able to get sound back from just one patch only if i enter edit in seq mode and adjust the balance knob but as soon as I exit and try another patch it goes back to no sound again

thank you