Loose Power Inlet on Back of Virus

[timotije2000]

I ordered one from ebay and I tried three different power supplies. One was original. The other two were same specs. No matter how I turned and the freaking plug, the screen would still dim and flicker. The connection just seemed too loose, like a hooker's vagina. To solve the problem this is what I did:

1. get a tiny flathead screwdriver and a flashlight

2. insert the driver into the power jack under/over the metal "lip" (negative) and pry it upwards/downwards slowly until you are close to the small "rod" (positive)

3. with the power off, insert and remove plug from the jack multiple times to get rid of any microscopic corrosion inside the jack as well as plug surface

I hope this helps.