Just to add onto this, I notice now that it is not only that parameter that dosent work when assigned to the soft knobs.
There seems to be a few others that have no response.
This is strange as most of them do work .
Can anyone test this out for me to make sure im not going crazy ?
Start a new patch in virus control.
Have osc 1 as a hypersaw.
Go to the page where you can assign things to the 3 soft knobs.
Set the first knob as 0sc 1 detune.
Then see if the soft knob can control the detune .
I think the other one I tried was freqeuncy shifter freq or somthing like that and that also was unresponsive.
Thanks .
|