[DJKeys]

I have channel pressure assigned to LFO 3 which is the LFO set up by default for vibrato. However, it doesn't seem to have any effect. I have the Chan pressure assigned to LFO 3 Assign amount and LFO 3 rate and it does nothing when I dig into the keyboard. The vibrato amount seems to be affected only by the LFO settings, as I can hear it cleary when I increase the amount. This happens when using HW or SW editing.

Any ideas why this does not work? Mod wheel seems to work fine as the source.

I also tried routing channel pressure to Filter 1 and 2 cutoff, and that doesn't work either. Is there an issue with aftertouch on the TI2?

I routed the Soft Knob 1 to the same destination, and the vibrato works fine.

I also tried routing channel pressure to Filter 1 and 2 cutoff, and that doesn't work either. Is there an issue with aftertouch on the TI2?

Thanks-

-dj