Quote:
|
Originally Posted by ben crosland
Quote:
|
Originally Posted by ZEBASTIAN
Hi ben.....at first I was using the TI with VC and USB as main out......the arps dont sync at all.....then I switched from usb to OUT 1 as main output, and its even worse because I hear everyhting distorted, everyhting is noise!!!
Im recording with logic 7.1 and I have set a pre-roll of 2 bars before recording 
I 've highlighted the tracks asigned for the TI in logic every time......and BTW....WHY THE TI CANT REMEMBER WHEN YOU CHANGE THE MAIN OUT? every time I open Logic Ti sets itself to Usb out.. |
OK - then this looks like it's something to do with your setup - hopefully we can get to the bottom of it. What sample rate are you working at, btw? |
Im working at 44.1 khz...
my set up is dual G5 2.0. 2 gb ram.
mac osx10.4.4 .....logic pro 7.1.1
Audio card is presonus firebox....buffer size used in logic is 128.
Process buffer range is set to "small"
24 bit and software monitoring...
Virus TI used with VC...midi over usb and audio over OUT 1.
if using usb for audio and midi then i dont get distorted sounds.....but in both cases Arps are a mess.