Is it sending out any data at all? Notation even?
Not an easy one to figure out from this side of the world.
Only things I can sugest are;
Put the KC in single mode to start.
Select midi channel 1 on the sequencer.
Then play the keyboard and press record on the sequencer.
Pretty sure you would have tried all that allready though.
The other thing is make sure the Virus's midi isn't setup to just send midi data to the internal parts of the KC (instead of going to the midi outs). All this is in the midi setup of the KC.
There are 3 choices;
internal - just the controls go to the Virus and won't go to midi out.
int+midi - go to both.
midi - only the controller data goes to the midi out and it doesn't go to the internal engine of the KC.
Look on page 119 of the manual for this stuff.
PS. I thought the manual was quite good. I read it while I while waiting for my VC and when my VC finally came, I knew the thing inside out.
|