There was a thread about this on the Access site recently, in the end Jorg from support detailed how to get it to work.
http://www.virus.info/forum/index.ph...&threadID=2385
Quote:
To use the Virus TI Vocoder please go on like this:
- select an 'init" patch in your Virus TI Control PlugIn
- make sure you got a signal coming through the analog inputs of the Virus TI
(you can easily check that by going to the TI Control "FX" page and changing the INPUT Mode from "Off" to "Static" - if you hear an audio signal then, then everything is set up correctly - switch back the INPUT again to "Off" after checking that)
- now activate the Vocoder (press the Edit button in the distortion section twice and scroll with the parameter buttons until you see Vocoder 1/4) and set its mode to "Oscillator" or "Osc Hold"
- move both SPREAD parameters completely to the right
- move the CENTER parameter to its middle position
- now hold down a chord on your masterkeyboard or send notes to the TI via your sequencer
-> you now should hear the vocoded audio signal
Now you can start from there and change oscillator settings, etc. to create a unique vocoder sound. So changing the oscillator waveforms and other oscillator setting will have a general influence of the sound of course.
Let me know how far you get with this and if you need further assistance.
By the way there's no further documentation on the Vocoder available, I'm afraid.
Best wishes,
Jörg Hüttner
|