[S|N]

First of all, thanks for your interesting hollow!!

I am going mad about this trouble...


Here's my settings:

Midi Dump TX -> SingleBankA

Midi Dump RX -> ForceToBankA

Midi -> GlobalChan 1

Midi -> Panel Int+Midi

Midi -> ClockRx Disable

Midi -> DeviceId 1

Midi Control -> LoPage SysEx

Midi Control -> HiPage SysEx

------------------------------------

Under Cubase Sx: set the tempo track to 4 bpm, midi IN and OUT to my midi interface, Channel 1.

RESULT: press play, the sequencer starts and I can see a little "C" between "1" and "A0" (where A0 is the first of bank A),the little "C" keep flashing on even if i stop the sequencer....nothing happens....bank A ramains the same.

p.s. the error "sysex wrong checksum" does not display....

Under SoundDiver: have raised timeout setting to 800 ms, send pause to 350 ms, play delay to 200. If I load the midi file or the sounddiver file is the same: "sysex with wrong checksum" ...a little "SE" appears between "1" and "A0"....i notice that the sounds are changed but they are not labelled,for istance I can see the names of every sound into sounddiver but everytime i try to transmit dispays the usual fuckin' error!!!

I start thinking about my midi interface....broken???....

obviously I connect midi IN of the midi interface to midi OUT of the Virus
and midi OUT of the midi interface to midi IN of the Virus.....i suppose this is correct....

I have also tried several changes to my settings doing a lot of combinations...nada de nada!!

waiting for an angel.....

bye byez