Quote:
Originally Posted by Doc Jones
1. Certain sounds don't reload properly when the VC is saved with the daw (cubase etc.) I have found more sounds that don't reload properly and hence lose all tweaks - Q Should I continue reporting the individual sounds that don't reload correctly or is the fix that Access is working on going to correct all the sounds?
|
It seems there are certain sounds that contain illegal values which are causing these problems, Syrys BC is known - please send me a list of any others you find and I will make sure they are fixed for the next release.
Quote:
Is anyone else able to save individual sounds with their songs via sysex transfer? If so, are you doing the sysex dump via midi cable or over usb?
|
Yes, Arrangement Dumps works fine for me with either usb midi or normal midi.
Quote:
3. System Reset. In the virus C there was a way to reinitialize the synth (if there were problems) by holding down a key when powering on. Ben had stated that I should do a soft power down (normal method) plus hold the arp edit button, but this didn't seem to do anything related to a system reset. Can anyone else do a system reset this way?
|
Soft Power Off, so that the TI is in Standby. Then press and hold Arp Edit for a second or two. You should see the BPM and Osc Vol LEDs flash. The TI is now reset.
Quote:
4. In the virus control - when copying a sound from one part to the other, (via drag and drop) it doesn't copy the sound with all the tweaks I made to it. Rather it just copies the original sound (prior to tweaks) Is this normal. Ex. I have a sound in part one - I tweak it heavily. Now I would like to load that same exact tweaked sound into part two to control from another midi track. In the VC I highlight first part sound (tweaked), drag and drop it into part 2. I honestly would think it would be the same exact (tweaked) sound, but rather it reverts to the original sound (before tweaks) for part 2. I suppose I can just save the tweaked sound to a ram slot and then reload it into part 2, but the drag and drop would be much faster.
|
I'd be surprised if
none of the tweaks are copied? There is an issue with some of the filter envelope parameters in this situation, but that has been identified and a fix is forthcoming. Other than these parameters, I can drag/drop tweaked patches between parts just fine?