To get this, I would:
1. Set osc 1 to supersaw with some detune, width fairly narrow.
2. Set osc 2 to full on square (pulse), and do 50/50 osc balance.
3. Use low pass filters with about 40%-60% resonance and keyboard tracking set to +max, tune the resonant bit to the rest of the notes. Use this to get the pure-sounding sheen over the top.
4. Saturate your filters with some light distortion, then apply light distortion in the effects section.
5. Add a small amount of reverb with a long-ish tail and a fairly dark colour.
7. EQ out everything below 300hz.
8. Mayhaps add/adjust analog boost.
9. Set mono
Not tried it, but... Yus. That would be my guess.
-Annikk
|