Try using hypersaw instead of patch voice unison.
Using classic saws x 8 unison x 4 note chords = 32 voices. If you have a third oscillator enabled this figure is greater, perhaps 48 voices in total, so it would be toward the limit of the snow's hardware.
Whereas using hypersaw (9 saws [or 18 saws if both oscs are used] while using just 1 voice poly) x 4 note chords = 4 voices, for pretty much the same (or even thicker) sound. Much more economical.
The 'rough' figure for poly for snow is 50 voices (when hypersaw is used), so you can use plenty of release on the envelopes, or even add a little patch unison (within reason) or a third osc if wished without note stealing.
__________________
PS > And another thing! Will the Ti|3 have user customisable/importable wavetables?  A ribbon-controller or XY-Pad might be nice, too, please! Thanks!
Last edited by Timo : 28.05.2014 at 03:51 PM.
|