Quote:
Originally Posted by IamEvil
Close ? It's spot on bar some EQ to filter the low end.
I didn't save the sound as I knocked it up in a few seconds before I shot off to work. It's exactly how I stated earlier.
Get a -Init- patch, change osc 1 to a square wave, change osc 2 to a sine wave and lower it down by 1x octave (12 semitones) , turn the portamento to around 30-40ish and turn on a distortion to your taste.
That is it, nothing else was touched apart from I turned the delay on for the recording.
[edit]
Looking at the screen grabs , it appears they've used ring modulation instead of distortion.
|
Thank you for explaining but somehow I can not get the job done.. (I know, I am a noob..sorry)
This is what I did:
TI OSC PAGE
TI FX1 PAGE
Here's the TI midi patch file:
http://www.speedyshare.com/files/267...quare_test.mid
And this is how it sounds:
http://www.speedyshare.com/files/26766281/test1.mp3
Somehow it wont sound like the
original sound..
What am I doing wrong here?