Hey guys!
Nice to see more psy-people around here.
Two main ingredients for the psybasslinesound on the TI is putting the phase init right and the envelopes.
You can make a psybass out of most osc and most of them are relatively simple to make. But it's all relative to your bassdrum which should always be in the same tone.
Having said that, a good bassound isn't everything. You need a lot of EQ and sidechain compression. If you are using Cubase for sidechain compression, be sure to put compression of the bassline on insert 7 or 8. This way it will be behind the EQ in the chain.
A starting point for a psysound could be:
Osc 1 Saw, Osc 2 Wave 46
Portamento 3/4
Sub osc halfway open
Saturation 3/4 ' Middle'
Envelopes
Filter
A 10
D 100
s 15
R 40
Amp
A 0
D 0
S 100
R 10
Filters ( ser6)
Velocity open op filter 1
1:BANDPASS 45 with 20 resonance
2: BP or HP. Bandpass + 20. Highpass very low
LFO's
LFO 1
1/1 Sine, Both OSC to full
LFO 2 1/4 triangle
to Filter1 -20%
to filter2 + 20%
Just try this and experiment, You'll get the hang of it.
|