Basically, I had to pull the plug for 30s and remove all audio cables, and turn the unit back on holding the Exit button, putting it into update mode. The 64 bit drivers wouldn't see the Virus when it was already in update mode - it would just say "Scanning for TIs...".
So, I had to go to my 32 bit laptop, install 3.2 again...fine. Tried 3.3 64 bit again, same issue. Then tried 3.3 32 bit - same issue again. Going back to 3.2 until it's fixed - not sure how Access manage to bugger something as stupid as the installer for a firmware update - that should be fundamentally stable!
Anyhoo, I'll wait again - glad that some progress is being made on the 64 bit front though. Hope other people have more success...
|