I use FL Studio 8 and I have not run into latency problems. I setup in this fashion.
1. Open TI in a new channel
2. Set its Port Number
3. Set it to an effects channel, I always use four, but anyone of them but the master is fine.
4. I pull up the FL effects page and click on effects channel four, then for the "input" at the upper right of the effects page I choose Virus ASIO 1&2. Next I select the output in the lower right corner of the effects page and select Virus ASIO 1&2.
5. Now in the dialog box for latency compensation I select "Pre", then choose to "sync to master".
6. Make sure you unclick the disk icon at the bottom of of the Effect Channel Four strip.
7. Get into VC, go to the first page past the FX1 and FX2 page and select for output "Out 1 L+R".
8. Finally go to the last page in VC and for "Surround Sound" output select none.
This should work,I have been working very well with 3.0.5 and FL, as far as not crashing constantly.
There Ya GO
Goodluck
|