I'm at work atm and don't have the TI in front of me, so can't post a screenshot
is it possible to connect an envelope to the osc1 and osc2 pitch together?
Sure. If you're just getting acquainted with the TI, I suggest you start with the init patch (RAM C127 if I remember correctly):
- go to the mod matrix
- select "Filter Envelope" as the source
- select "Osc1 Pitch" as the destination, dial in the desired amount
(you might want to turn "Osc Balance" knob fully counter-clockwise, to hear Osc1 only). You should hear the effect of filter envelope on Osc1 pitch.
- now turn "Osc Balance" fully clockwise, to hear Osc2 only;
- move down one line in the mod matrix, select "Osc2 Pitch" as the destination, dial in the desired amount. You probably want the same modulation amount as for Osc1, although you don't have to.
- put Osc Balance at the middle position, to hear both oscillators modulated by the filter envelope.
hope my explanation is not too confusing
good luck!