OK, this ain't gonna be pretty, here goes.
I have 3 audio devices or soundcards in my set up;
- Built in PC sound card
- VirusTi Audio (USB)
- Yamaha MW12 mixer device (inbuilt USB)
I have no idea how to
correctly configure each of these in Cubase Studio 4.
I have 4 USB ports on the PC, and have installed a PCI 5 port-USB card. I have the MW12 connected to a dedicated USB, the Virus TI connected to a dedicated USB, and my RADIAS connected to a dedicated USB.
I also have a Korg Karma which I connect the MIDI ports to a Edirol UM101 USB MIDI device which in turn is also connected to the PC.
I can record and playback MIDI (
sometimes) from each of the Synths.
I have each of the synth Main Outs connected through 1/4" jacks to the various inputs on the MW12. I can control each of these using a slider on the MW12.
Channel 1: VirusTI Left
Channel 2: Virus TI Right
Channel 3: RADIAS Left
Channel 4: RADIAS Right
Channel 5/6: KARMA Left and Right
Channel 7/8: Not Used
Channel 9/10: from Laptop soundcard
Channel 11/12: Not used
I have my separate laptop
headphones-out connected through a 6mm jack socket to Phono lead into channels 9/10 of the MW12.
I have no idea what the following buttons on the MW12 do;
ST - on each channel (these are all ON)
PFL - on each channel (these are all OFF)
1-2 - on each channel (these are all ON)
ST/Group - under CR/Phones knob (depressed)
to ST - to left of CR/Phones knob (depressed)
2TR In/ to USB (depressed)
How's that for a starter for 10 sir?
EDIT: I have started a separate thread about this
here.