I didn't actually use presets there - I just set it into "manual" mode and used the knobs to tweak (read the manual for that one when you get it Matsa). Manual mode gives a "what you see is what you get" setup as far as the knobs and buttons go (kinda like using a "real" amp). I put it into manual mode and played the same 2 synth sounds, tweaking the Tonelab a little bit each time I recorded a new one.
After quickly recording this demo I sat down and tweaked my synth patches too - damn rewarding!! Could really tune my synth sounds to trigger the TL in many very nice ways.
One tip for any buyers...
Make sure you read the manual to find out what the amps do, as some of the vinatge amps don't use all the knobs they have labeled there - in these cases the left over knobs do things which aren't written on the face of the unit. Found this one out today.
|