Hey guys, thanks for the responses. I've just had a response back from Access on this and it goes:
- switch off the TI and remove the power cable
- remove the USB and any Midi cables from the TI
- hold down the ARP EDIT button for a few seconds and put the power
cable back in while doing this
- then put back the USB and Midi cables whenever the TI is already up
and running
It must be pointed out that the USB cable is not connected at any point during my setup (I've just used it once when I upgraded the OS). In respect to the above steps, I thought the transpose button switched on my TI. I'll see how it goes because it makes some beautiful sounds but if it gets in the way of my work, it's off straight back to Soundcontrol and a V-synth will be on the cards instead.
D
|