hello ben, thanks for your help.
a reset does not help.
funny thing is, this function should be very simple - I just set the output of a part from Out1 L+R to Out2 L+R or Out3 L+R - I route the output to my mixer and on the 3 stereo channels I should get the different sounds isnt it?
the second output function indeed does work. I can sent the effects to output 2 or 3 and I can sent the normal signal to 2 or 3 (then use balance to mix them together - this works fine). but as I said, that is no help because with this function all parts are routed to the same second output (thats not what I want - I want 3 groups of different parts routed to 3 different outputs).
any ideas??
Thanks.
Dries
|