Easy question....
 

Hello.
I am sure this is obvious and been asked before, but I cant think of the words to search for.

I am using virus control in my Daw and I prefer to record my sound by using the 1/4 " outputs instead of usb.

My question is, say that I am using virus control and recording what I am playing in real time, if I do a filter cutoff sweep for example using the actual knob on the virus ti hardware. How do I make it so I can see the filter movment inside the virus control vst ?

Now I have it set that I can HEAR the effect happening (Example : Filter is set to bandpass) when I move the knob, but do not see the upwards pointing triangle that you see in the filter section moving at all.

I am sure at one point I had it set this way but cannot remember what it was set to ??

Thanks.

You should be seeing the virus control vst reacting to knob turning on the hardware. If you not seeing this somethings not set up correctley. Does Virus control find your TI when Its first open?

You dont't have to use the TI as your soundcard also .