is there any warning before the internal RAM BATTERY goes out?
 

...or does it just fail suddenly.

just got the Indigo 2 and the "warranty void if removed" sticker is intact so i'm kinda worried i'll lose all my saved patches soon if the battery has never been changed.

the manual suggests replacing it every 3 or 4 years

anyone?

is the 3 or 4 years the manual suggests an underestimate of how long the battery lasts or is that pretty accurate?

any info would be greatly appreciated from those who have had to change their battery.

thanks!

Don't be too paranoid about your battery, that said... stay vigilant in checking it.

Things can go badly real quick. My old KORG POLY-61 went from being a nice functional poly synth, to a retarded turd with corrosion on the main PCB in a matter of a few years.

how do i check it?

Not tryin' to cop out, but ask Access directly for details about battery maintenance. They should be able to help, hopefully.

will do!

would still like to hear from anyone who's had their virus battery die and/or had it changed.

Hi, you can see the battery (a standard CR2032 lithium flat, disc-shaped battery) in my re-potting thread. http://infekted.org/virus/showthread.php?t=31443

For example, you can clearly see it here, in the centre, along the bottom.



Looks like it's just a simple clip holding it in place, no soldering needed.

BTW, I have an old Virus Indigo v1, and I haven't needed to change the battery yet. The same with a 15 year old Korg Trinity which has the same type of battery.

I think the standard Virus hardware warranty only lasts 1 or 2 years, so breaking that seal wont affect you if it's older.

ah, good to know. guess i won't fret.

had a jp8000 battery go out on me which is perhaps why i'm a bit sensitive. :)




by the way, i've been mulling over the pics of that source post of yours.

from the looks of the innards seems like adding wood cheeks wouldn't be too hard at all.

might be neat to give it a Sequential Circuits Prophet vibe.

ever thought of doing that to yours?

wondering if it would compromise the structures integrity.

do the aluminum sides seem to play a large role in the strength of the frame?

The end 'cheeks' don't really affect the structural integrity of the fascia (the main control panel) as the fascia is mainly bolted to the chassis both at the front and rear, but the cheeks are attached very securely to the chassis itself (along with just one screw at the rear into the back of the fascia, where the jack sockets are). They use perpendicular brackets to fit to the chassis (and rear), as you can see in the following photo:



I think a minimum of three screws are required on the bracket either side attaching the cheeks to the chassis....



And one additional screw on the bracket either side at the back attaching the cheeks to the rear of the fascia too.



No screws are needed along the sides of the cheeks to the fascia, as the fascia is already held solidly down to the chassis via a bracket along the red dotted lines:



If you see my re-potting guide, you will see how it all fits together and what is needed to do so:-

http://infekted.org/virus/showthread.php?t=31443

The aluminium cheeks are aesthetically decent as they show no screws from the outside, even though they have brackets attached to them on the inside.



If you wished to replace the metal cheeks with wood, I think the most trickiest issue would be how to attach the brackets to each wooden cheek securely. You'd need really dense wood, I think, unless you drilled through to the outside (to bolt the bracket internally) like they did with the Virus TI|1 desktop:



However, user DeFex made custom wooden end cheeks for his Virus desktop to make a kinda modular work surface.