Yes you can, but you need to find the manual or goto the website and find the midi cc listing for each vsti you're using, then map those cc numbers to your midi controller. Most of them are the same or very similar, but some are different. Some support midi learn where you click the midi learn button, turn a knob on your midi controller and it will bind to it.

Also I dont believe freeze was in sx1, or at least it was extremely shit if it was. Its only just got useable on sx3 so it might be worth looking to upgrade (only ?100 from arbiter.co.uk)

ten

But how?

In my General Remote in device setup theres only MIDI mixer VSTi mixer mixer command and no assignment listet in the popup.

You need to find out how to assign certain cc numbers to the knobs on your midi controller. Assign the cc numbers that are the ones you want to control on the vsti, this is why u need the cc map for the vsti. You will also want to read the manual to your midi controller to find out how to assign certain ccs to the knobs. Dont worry about all that general remote mixer shit, its a load of crap in sx1 and doesnt work properly.

ten

It should be the same concept in SX1 as in SX3.

You would think so wouldnt you.

A lot of things are broken and were left broken in sx1 only to be fixed in sx2/3.

Either way, you need to read the manuals for you're controller and sx.

ten

I have no problem with finding the parameter numbers, my problem is HOW TO ASSIGN THEM TO MY MIDI CONTROLLER?

I give up, rtfm and get on with it jack ass.

ten

How much do a upgrade cost?

?100 from sx1>sx3

I would suggest going to www.cubase.net and asking there. They will be able to explain better.

ten

Yes i just found this forum right before you told me;)

Thanks still